Yuku free message boards

You could probably hook up another brand of digital controller to Artin Digi-Pro. You would have to open both controllers and follow the wires of the other brand controller to make sure that the wires match. Then you will have to find the resistor values for each step that is used on the Digi-Pro controller. You can use an RPM meter and a potentiometer or an oscilloscope to find each step. Record the values for each step and then change the resistors on the Pro-X controller (if possible) so it matches the Digi-Pro controller. At one point I was going to do this with an N-Digital controller because the resistors are easily changed on this controller, not sure about the Pro-X controller. If you take some pictures of the inside of the Pro-X controller and post them here, I can tell you what I think.

Best regards,
Brian